Fishing Equipment Tips

Fishing Equipment - Anchor Pulley, Keep it Quiet

If you use an anchor pulley, you risk spooking the fish as most pulleys eventually start to squeak. Try this alternative to a pulley:

Get a large U-bolt, a few nuts and washers, and an old-style glass or porcelain fencepost insulator.

Slip the insulator on a U-bolt, drill a couple of holes to accommodate the bolt, and tighten it to the mounting surface. The anchor rope will slide freely in the insulator’s groove, and the anchor lowers and raises as effortlessly as with a pulley, especially once the rope is wet.

Fishing Equipment Tips – Cheap and easy depth finder

Using two felt-tipped markers (red and black) mark an anchor rope as follows: A single red mark around the rope at five feet, a red and black mark at 10 feet, a single red mark at 15 feet, two black marks at 20 feet, a single red and two black marks at 25 feet and three black marks at 30. Use the color code red for every five feet and multiples of black for 10 feet.

Fishing Equipment – Netting baitfish

Increases the efficiency of your minnow scoop by putting a bend in it. Just turn the wire handle down 90 degrees, then push the net back on line. The forward-positioned net makes it much easier to trap a baitfish against the inside of an open-top bucket.

Fishing Equipment Tips– A Cheap Anchor For A Fishing Boat

For holding a good-sized boat over a rocky bottom, use a large swivel snap to fasten four fee of heavy chain to a standard mushroom anchor. You can get one from a junkyard. The chain boosts the anchor’s weight and holding power, provides convenient handles for lowering and raising, and gives extra leverage when an anchor jams in rocks or snags. When he brings it aboard, he coils the heavy chain on a bed of old foam-rubber pads so it doesn’t rattle around or dent his boat. In calm water, he simply unsnaps the chain and uses the mushroom anchor by itself.